❮ ❯

Units are provided many standard features not found on other equipment including full height hinged access doors with S.S. hinges and fasteners with security locks. 25 ton unit shown.

1. Hinged Access Doors (Full Height)
2. Fully Welded Lifting Brackets
3. Triple Hinged Doors
4. Door Locks
5. Polymer Handles and Clasps
6. Integral Roof Drip Flashing

❮ ❯

Exterior fasteners are made of high quality stainless steel for both strength and longevity.

1. Heavy Gauge Stainless Steel Hinge
2. Stainless Steel Rivets
3. Stainless Steel Screws
4. Stainless Steel Bolts on all Framing
5. Epoxy Painted Cabinet

❮ ❯

All units are provided with a roof drip edge to prevent water weeping. Exterior panels that are installed with screws are additionally protected with a polymer UV resistant caps.

1. Roof Drip Edge
2. Screw Caps (Polymer UV Resistant)

❮ ❯

Multiple heavy steel gauge welded lifting brackets are provided to rigging and setting of the units.

1. Multiply Welded Lifting Brackets

❮ ❯

Coil Guards are offered as an accessory for those installations that required tamper resistant features.

1. Condenser Coil Guards

❮ ❯

The units offer full access via fully hinged access doors to maintenance areas of the unit while having screwed panels that do not require service access.

1. Full Access to each section with panels and access doors.

❮ ❯

This 25 ton unit is provided with condenser coil guards and the high efficiency low noise vari-speed condenser fans.

1. Condenser Coil Guards
2. High Efficiency Low Noise Condenser Fans

❮ ❯

The condenser fan assembly is a to mounted assembly which incorporates the fan shroud and frame into a single piece design. This makes removal and servicing much easier than traditional fan designs.

1. Single Piece Condenser Fan and Shroud Assembly

❮ ❯

The roof panels are installed with a “Standing Seam” to prevent water leakage and to form a strong unit structural joint.

1. Standing Seam Roof